Publications by authors named "Aleksandr M Khegai"

2 Publications

  • Page 1 of 1

Compact and efficient O-band bismuth-doped phosphosilicate fiber amplifier for fiber-optic communications.

Sci Rep 2020 Jul 9;10(1):11347. Epub 2020 Jul 9.

G.G. Devyatyh Institute of Chemistry of High-Purity Substances of the Russian Academy of Sciences, Nizhny Novgorod, 603600, Russia.

During last decades there has been considerable interest in developing a fiber amplifier for the 1.3-[Formula: see text]m spectral region that is comparable in performance to the Er-doped fiber amplifier operating near 1.55 [Formula: see text]m. It is due to the fact that most of the existing fiber-optic communication systems that dominate terrestrial networks could be used for the data transmission in O-band (1260-1360 nm), where dispersion compensation is not required, providing a low-cost increase of the capacity. In this regard, significant efforts of the research laboratories were initially directed towards the study of the praseodymium-doped fluoride fiber amplifier having high gain and output powers at the desired wavelengths. However, despite the fact that this type of amplifiers had rapidly appeared as a commercial amplifier prototype it did not receive widespread demand in the telecom industry because of its low efficiency. It stimulated the search of novel optical materials for this purpose. About 10 years ago, a new type of bismuth-doped active fibers was developed, which turned out to be a promising medium for amplification at 1.3 [Formula: see text]m. Here, we report on the development of a compact and efficient 20-dB (achieved for signal powers between [Formula: see text] and [Formula: see text] dBm) bismuth-doped fiber amplifier for a wavelength region of 1300-1350 nm in the forward, backward and bi-directional configurations, which can be pumped by a commercially available laser diode at 1230 nm with an output power of 250 mW. The compactness of the tested amplifier was provided by using a depressed cladding active fiber with low bending loss, which was coiled on a reel with a radius of 1.5 cm. We studied the gain and noise figure characteristics at different pump and signal powers. A record gain coefficient of 0.18 dB/mW (at the pump-to-signal power conversion efficiency of above 27[Formula: see text]) has been achieved.
View Article and Find Full Text PDF

Download full-text PDF

Source
http://dx.doi.org/10.1038/s41598-020-68243-4DOI Listing
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC7347876PMC
July 2020

Characterization of a single-frequency bismuth-doped fiber power amplifier with a continuous wave and modulated seed source at 1687  nm.

Appl Opt 2020 Feb;59(6):1558-1563

In this paper, we report the performance of a bismuth-doped fiber amplifier at 1687 nm. This wavelength region is particularly interesting for laser-based spectroscopy and trace gas detection. The active bismuth-doped fiber is pumped at 1550 nm. With less than 10 mW of the seed power, more than 100 mW is obtained at the amplifier's output. We also investigate the signal at the output when a wavelength-modulated seed source is used, and present wavelength modulation spectroscopy of methane transition near 1687 nm. A significant baseline is observed in the spectra recorded when the fiber amplifier is used. The origin of this unwanted background signal is discussed and methods for its suppression are demonstrated.
View Article and Find Full Text PDF

Download full-text PDF

Source
http://dx.doi.org/10.1364/AO.384413DOI Listing
February 2020